Installation guide

5-20
Cisco 6260 Hardware Installation Guide
OL-2365-01
Chapter 5 Troubleshooting
Alarms
The source of the IMA group alarms in Table 5-17 is one of the following interfaces: ATM0/IMA0
through ATM0/IMA3.
Table 5-18 describes NI-2 card redundancy alarms.
Tx Link Unusable—FE
4
Critical The far end is reporting that Tx is unusable.
Rx Link Unusable—FE Critical The far end is reporting that Rx is unusable.
1. LIF = loss of IMA frame
2. LODS = link out of delay sync
3. NE = near end
4. FE = far end
Table 5-16 IMA Link Network Interface Alarms (continued)
Alarm Severity Description
Table 5-17 IMA Group Alarms
Alarm Severity Description
Start-up—FE Critical The far end is starting up. The declaration of this failure
alarm might be delayed to ensure that the far end
remains in startup.
Configuration Abort Critical The far end is trying to use unacceptable
configuration parameters.
Configuration Abort—FE Critical The far end is reporting unacceptable
configuration parameters.
Insufficient Links Critical Fewer than P
Tx
transmit or P
Rx
receive links are active.
Insufficient Links—FE Critical The far end is reporting that fewer than P
Tx
transmit or
P
Rx
receive links are active.
Blocked—FE Critical The far end is reporting that it is blocked.
Timing Mismatch Critical The far end transmit clock mode is different from the
near end transmit clock mode.
Table 5-18 NI-2 Card Redundancy Alarms
Alarm Keyword Severity Description
Active/Standby NI2
type mismatch
C6100_CONTROLLER
_SLOT_MISMATCH_
ALARM
Major The NI-2 cards installed in slot 10 and slot 11 are
different types; for example, one is an OC-3c/OC-3c
NI-2 card and the other is a DS3/2DS3 NI-2 card.
Standby NI2 missing C6100_CONTROLLER
_SLOT_MISSING_AL
ARM
Major The secondary NI-2 card slot has been provisioned for
a standby NI-2 card, but the card is not installed in
the chassis.
Redundancy process failed NI2_RF_PROCESS_F
AILED
Major An internal redundancy software process has failed
and redundancy might not be available.