Installation guide

TABLES

Cisco 6260 Hardware Installation Guide

OL-2365-02

Table 1 Font Conventions xiv

Table 2 Command Syntax Conventions xiv

Table 1-1 IMA Group Interface Names 1-6

Table 1-2 Cisco 6260 Card Slot Assignments 1-11

Table 1-3 4xDMT LED Indicators 1-14

Table 1-4 4xDMT over ISDN LED Indicators 1-16

Table 1-5 4xflexi LED Indicators 1-18

Table 1-6 4xSDSL LED Indicators 1-20

Table 1-7 8xDMT LED Indicators 1-22

Table 1-8 8xDMT over ISDN LED Indicators 1-24

Table 1-9 8xG.SHDSL LED Indicators 1-26

Table 1-10 DS3/2DS3 NI-2 Card LED Group Indicators 1-32

Table 1-11 DS3+T1/E1 IMA NI-2 Card LED Group Indicators 1-35

Table 1-12 OC-3c/OC-3c NI-2 Card LED Group Indicators 1-38

Table 1-13 Pin Assignments for the Cisco 6260 I/O Module 1-45

Table 1-14 PEM LEDs 1-46

Table 2-1 CO Operating Environment Requirements 2-12

Table 2-2 Rack Space Calculation for the Cisco 6260 System Configurations 2-14

Table 2-3 Power Calculation for the Cisco 6260 System 2-14

Table 2-4 Tool and Equipment Requirements Checklist 2-16

Table 3-1 Installation Checklist—Cisco 6260 with a POTS Splitter Configuration 3-2

Table 3-2 Terminal Settings 3-21

Table 4-1 Installation Checklist—Cisco 6260 without a POTS Splitter Configuration 4-2

Table 4-2 Terminal Settings 4-20

Table 5-1 Service Interruptions Caused by Replacing FRUs 5-1

Table 5-2 System-Wide Problems 5-3

Table 5-3 NI-2 Card Problems 5-8

Table 5-4 NI-2 Card Cold Redundancy Problems 5-9

Table 5-5 Line Card Problems 5-10

Table 5-6 I/O Module Problems 5-14

Table 5-7 Fan Tray Problems 5-15