Installation guide

Figures
x
Cisco 6260 Hardware Installation Guide
OL-2365-02
Figure 3-6 Positioning the Power and Ground Terminals to Accept Wires 3-11
Figure 3-7 Insert Grounding Wire into Grounding Receptacle 3-12
Figure 3-8 Connecting Power to the Terminal Block 3-13
Figure 3-9 I/O Module Wire-Wrap Pins Close-up 3-14
Figure 3-10 E3 I/O Module BNC Connectors 3-16
Figure 3-11 E1 I/O Module BNC Connectors 3-17
Figure 3-12 E3 I/O Module BNC Connectors 3-18
Figure 3-13 E1 I/O Module RJ-48 Connectors 3-19
Figure 4-1 Mounting Options for Ear Brackets 4-4
Figure 4-2 Screw the Mounting Aids to the Rack 4-5
Figure 4-3 Mounting Aids Support the Chassis During Installation 4-6
Figure 4-4 System Ground Connection 4-8
Figure 4-5 Strip and Square Off Power and Ground Wires 4-10
Figure 4-6 Positioning the Power and Ground Terminals to Accept Wires 4-10
Figure 4-7 Insert Grounding Wire into Grounding Receptacle 4-11
Figure 4-8 Connecting Power to the Terminal Block 4-12
Figure 4-9 I/O Module Wire-Wrap Pins Close-up 4-13
Figure 4-10 E3 I/O Module BNC Connectors 4-15
Figure 4-11 E1 I/O Module BNC Connectors 4-16
Figure 4-12 E3 I/O Module BNC Connectors 4-17
Figure 4-13 E1 I/O Module RJ-48 Connectors 4-18
Figure 6-1 Removing the Bezel and Air Filters 6-3
Figure 6-2 Close-up View of Cisco 6260 Chassis with Fan Trays and Bezel 6-5
Figure 6-3 xTU-C Line Card Installation 6-8
Figure 6-4 Positioning the Locking Tab for the xTU-C Line Card Installation and Removal 6-8
Figure 6-5 NI-2 Card Installation 6-11
Figure 6-6 Positioning the Locking Tab for NI-2 Card Removal and Installation 6-11
Figure 6-7 I/O Interface Module Retaining Screws 6-20
Figure 6-8 PEM Installation 6-21
Figure C-1 xDSL Connector Pin Locations C-1
Figure C-2 BNC Connectors on the E3 I/O Module C-2
Figure C-3 RJ-48c Connectors on the E1 I/O Module C-2
Figure C-4 I/O Module Wire-Wrap Pins Close-Up C-3
Figure C-5 NI-2 Card Console and Auxiliary Connector C-4
Figure C-6 NI-2 Card Management Ethernet Connector C-5