System information

12-60
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
clock set
clock set
To set the storage router system clock to the given date and time, use the clock set command. Date and
time information is used for log files and the user interface.
clock set hh:mm:ss mm dd yyyy
Syntax Description
Defaults None.
Command Modes Administrator.
Command History
Usage Guidelines If the storage router should synchronize its date and time with a network time protocol (NTP) server, see
the ntp peer command.
Examples The following example sets the storage router date and time to June 22, 2001 at 14:39:00.
[SN5428-2A]# clock set 14:39:00 06 22 2001
Related Commands
hh:mm:ss mm dd yyyy The current time in hours, minutes, and seconds, followed by the current
month, day, and year. For example, 13:55:22 06 22 2001.
Release Modification
3.2.1 This command was introduced.
Command Description
clock timezone Specify the time zone for the storage router.
ntp peer Specify the name or IP address of the NTP server with which the storage
router will synchronize date and time.
setup time Run the wizard to configure the system date and time.
show clock Display the current system date and time, including the system timezone.