System information

12-57

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

clear scsirouter primary

To remove the storage router configured as the primary for the named SCSI routing instance, use the

clear scsirouter primary command.

clear scsirouter name primary

Syntax Description

Defaults None.

Command Modes Administrator.

Command History

Usage Guidelines At any given time, a SCSI routing instance can run on only one storage router in a cluster. If a SCSI

routing instance has the primary attribute set, the specified storage router will take over running that

instance upon system restart or whenever target and critical resources are available.

If the primary attribute is not set, the SCSI routing instance continues running on the node where it was

started until it is explicitly stopped (via a no scsirouter enable command), it automatically fails over to

another storage router in the cluster because targets or critical resources are unavailable, or an explicit

failover scsirouter command is issued. This is the default behavior.

Examples The following command removes the storage router configured as the primary for the SCSI routing

instance named lab2:

[SN5428-2A]# clear scsirouter lab2 primary

Related Commands

name The name of the SCSI routing instance.

Release Modification

3.2.1 This command was introduced.

Command Description

clear scsirouter

failover

Remove the designated primary or secondary storage router from the HA

failover list for the specified SCSI routing instance.

scsirouter primary Identify the storage router as the preferred storage router to run the named

SCSI routing instance.

scsirouter failover Add the storage router to the HA failover list for the specified SCSI routing

instance.