System information

12-567
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
zoneset
zoneset
To create a Fibre Channel (FC) switched fabric zone set, use the zoneset command.
zoneset name
Syntax Description
Defaults None.
Command Modes Administrator.
Command History
Usage Guidelines A zone set is a named group of fabric zones. A zone can belong to multiple zone sets. The SN 5428-2
Storage Router and each switch in the fabric maintains its own zoning database containing one or more
zone sets. When you activate a zone set, zone sets of the same name from all SN 5428-2s and switches
in the fabric are compiled and then the merged active zone set is redistributed to every SN 5428-2 and
switch in the fabric. This means that all switches and SN 5428-2s in the fabric have identical active zone
sets.
Caution If the storage router is connected to the FC switched fabric, all zoning changes (including the creation
of a new FC switched fabric zone set) are immediately propagated to other SN 5428-2 Storage Routers
and switches in the fabric.
See Chapter 5, “Configuring Fibre Channel Interfaces,” for more information about FC fabric zoning.
Examples The following example creates a zone set named foo:
[SN5428-2A]# zoneset foo
name The name of the zone set created by this command. Enter a maximum of 31
characters. The name must begin with an alpha character.
Release Modification
3.2.1 This command was introduced.