System information

12-484
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show scsirouter
The following is example output from the show scsirouter all failover brief command. This command
shows the eligibility of each SCSI routing instance for each storage router in the cluster.
[SN5428-2A]# show scsirouter all failover brief
Descriptions of eligibility ranked from most eligible to least:
Primary = This node is configured as primary and
all of the configured devices are available
All = All of the configured devices are available to this node
Some = Some of the configured devices are available to this node
None = None of the configured devices are available to this node
or a configured interface is unavailable
Unknown = Eligibility information has not been initialized
Scsirouter SN5428-2A SN5428-2B
---------- ---------- ----------
R1 All All
R2 Primary All
R3 Primary Some
R4 Primary None
Related Commands Command Description
accesslist Create an access list entity.
accesslist A.B.C.D/bits Add IP addresses to an access list.
clear counters
scsirouter
Reset accumulated operational statistics for the specified SCSI routing
instance.
delete scsirouter Delete the named SCSI routing instance or the specified element of the
SCSI routing instance.
restore accesslist Restore the named access list or all access lists from the named
configuration file.
restore scsirouter Restore the named SCSI routing instance from the named configuration file.
save accesslist Save configuration data for the named access list or all access lists.
save scsirouter Save configuration information for the named SCSI routing instance.
save system Save selected system configuration information.
scsirouter enable Stop or start the named SCSI routing instance.
scsirouter failover Add the storage router to the HA failover list for the specified SCSI routing
instance.
scsirouter serverif Assign a Gigabit Ethernet interface, IP address, and optionally a VLAN to
the named SCSI routing instance.
scsirouter target
maxcmdqueuedepth
Specify the maximum number of commands allowed at any given time from
each iSCSI session to the specified target.
setup scsi Run the wizard to configure a SCSI routing instance.