System information

12-455
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show interface
Related Commands
Total Link Reset Total number of link reset primitives.
Rx Offline Seq Number of offline sequences received. An OLS is issued for link
initialization, an NOS state, or to enter the offline state.
Tx Offline Seq Number of offline sequences issued by this port.
Total Offline Seq Total number of offline sequences issues by this port.
AL Init Count Incremented each time the port begins AL initialization.
LIP_F7_F7_Count A loop initialization primitive frame used to acquire a valid AL_PA.
LIP_F8_F7_Count A loop initialization primitive frame used to indicate that a loop failure
has been detected at the receiver.
Total LIPS Received Total number of loop initialization primitives received.
AL Init Error Count Number of times the port entered initialization and the initialization
failed.
LIP_F7_AL_PS Count This LIP is used to reinitialize the loop. An L_port, identified by
AL_PS, may have noticed a performance degradation and is trying to
restore the loop.
LIP_F8_AL_PS Count This LIP denotes a loop failure detected by the L_port identified by
AL_PS.
LIP_AL_PD_AL_PS Count Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets
performed.
Table 12-33 Description of Port Attributes in the “show interface stats” Command Output (continued)
Port Attribute Description
Command Description
interface ge? Configure various operational parameters associated with the Gigabit
Ethernet interface.
interface ha ip-address Specify the HA interface IP address and subnet mask.
interface mgmt
ip-address
Specify the management interface IP address and subnet mask.
setup mgmt Run the wizard to configure the management interface.
setup cluster Change the configuration of the high availability environment.