System information

12-424
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show fcip
The following is example output from the show fcip command. In this example, the FCIP instance is
configured to use a TCP server connection.
[SN5428-2A]# show fcip fcip2
Instance Device I/F Network I/F
-------- ---------- -----------
fcip2 fci2 ge2 10.1.40.42
Description
-----------
Testing SAN
Destination LocalMode IpAddress IsConnected
----------- --------- --------------- -----------
dest2 tcpserver 10.2.50.51 TRUE
LinkState
---------
UP
fcip1 Trace Status
------------------
pktTraceMask On, mask 0xffff
mboxTracing On
mboxCmdCount 0
fcip1 Connection Information
----------------------------
idlePingDelay 60
tcpPort 3225
rxTcpWindowSize 262144
maxRxTcpWindowSize 262144
txTcpWindowSize 262080
txTcpCongestionWindowSize 268800
maxTxTcpWindowSize 262144
frIn 0
frInHiWater 688
Table 12-27 describes the fields in the display:
Table 12-27 Description of Fields in the “show fcip” Command Output
Field Description
Instance The name of the FCIP instance.
Device I/F The internal Fibre Channel interface associated with this FCIP
instance.
Network I/F The Gigabit Ethernet interface and IP address associated with
this FCIP instance.
Description The FCIP instance description, if any.
Destination The name of the FCIP peer destination.
Mode The connection protocol type used by this FCIP instance.
IpAddress The IP address of the peer FCIP instance.
IsConnected The state of the connection between this FCIP instance and its
peer.
LinkState The state of the link.