System information

12-40

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

cdp enable

To enable Cisco Discovery Protocol (CDP) on the SN 5428-2 Storage Router, use the cdp enable

command. To disable CDP on the storage router, use the no form of this command.

cdp enable

no cdp enable

Syntax Description This command has no arguments or keywords.

Defaults CDP is enabled.

Command Modes Administrator.

Command History

Usage Guidelines CDP is enabled by default in order to send or receive CDP information. CDP can be switched on or off

for each specific interface via the cdp interface command.

Examples The following example enables CDP on the storage router:

[SN5428-2A]# cdp enable

Related Commands

Release Modification

3.2.1 This command was introduced.

Command Description

cdp holdtime Specify the amount of time the receiving device should hold a CDP packet

from the SN 5428-2 Storage Router before discarding it.

cdp interface Switch CDP on or off for the specified interface.

cdp timer Specify the amount of time between transmissions of CDP packets from the

SN 5428-2 Storage Router.