System information

12-388
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show cdp neighbors
show cdp neighbors
To display detailed information about neighboring devices discovered using CDP, use the
show cdp neighbors command.
show cdp neighbors [interface if-name] [detail]
Syntax Description
Defaults None.
Command Modes Administrator or Monitor.
Command History
Usage Guidelines Use the show cdp neighbors command to display brief or detailed information about neighboring
devices discovered using CDP. Add the interface keyword and the interface name to limit the display to
neighbors connected to that specific interface.
Use the detail keyword to display detailed information about all devices, or devices connected to the
specified interface.
Examples The following is example output from the show cdp neighbors command:
[SN5428-2A]# show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device-ID Capability Platform Remote Port
--------------------------- ---------- --------------------- -----------
SCA05600126(kal6-lab-swa.cm TSI WS-C6509 4/16
SCA05600126(kal6-lab-swa.cm TSI WS-C6509 4/12
JAB04140GZC(kal6-lab-z4-swa TS WS-C2948 1/23
interface if-name (Optional) Keyword and name of the interface connected to the neighbors
for which you want information.
detail (Optional) Display detailed information about a neighbor (or neighbors)
including network address, enabled protocols, holdtime, and software
version.
Release Modification
3.2.1 This command was introduced.