System information

12-383
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
show cdp
Related Commands
Sending a holdtime value of nn seconds The amount of time (in seconds) the storage
router directs a neighbor to hold the CDP
advertisement before discarding it. This field is
controlled by the cdp holdtime command.
Sending CDPv2 advertisements are enabled Indicates that CDP version 2 advertisements are
enabled.
Table 12-21 Description of Fields in the “show cdp” Command Output (continued)
Field Definition
Command Description
cdp enable Enable or disable CDP on the SN 5428-2 Storage Router.
cdp holdtime Specify the amount of time the receiving device should hold a CDP packet
from the SN 5428-2 Storage Router before discarding it.
cdp interface Switch CDP on or off for the specified interface.
cdp timer Specify the amount of time between transmissions of CDP packets from the
SN 5428-2 Storage Router.
show cdp entry Display information about a specific neighbor device listed in the CDP
neighbors table.
show cdp interface Display information about the storage router interfaces on which CDP is
enabled.
show cdp neighbors Display detailed information about neighboring devices discovered using
CDP.
show cdp traffic Display information about traffic between devices gathered using CDP.