System information

12-362
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup time
Examples The following shows example output and input for the setup time command:
[SN5428-2A]# setup time
#########################
## Date and Time Setup ##
#########################
To provide correct information in log files and user interfaces, the SN5428-2
must have a reasonably accurate date and time.
To use Daylight Savings Time or specify time zone by geographic region
use the "clock timezone" command.
The time zone must be entered as an offset from GMT.
0=[0000 GMT] 1=[-0100 WAT] 2=[-0200 AT]
3=[-0300 Brazil] 4=[-0400 AST] 5=[-0500 EST]
6=[-0600 CST] 7=[-0700 MST] 8=[-0800 PST]
9=[-0900 YST] 10=[-1000 AHST] 11=[-1100 NT]
12=[+1200 IDLW] 13=[+1100 WST] 14=[+1000 GST]
15=[+0900 JST] 16=[+0800 CCT] 17=[+0700 WAST]
18=[+0600 ZP6] 19=[+0500 ZP5] 20=[+0400 ZP4]
21=[+0300 BT] 22=[+0200 EET] 23=[+0100 CET]
Time Zone? [0-23] 6
If a Network Time Protocol (NTP) server is in use on a network reachable
via the SN5428-2 management interface, it may be used to keep the SN5428-2 date
and time in sync with the rest of the network.
NTP Server IP Address? [A.B.C.D] 10.1.60.86
If you enter the NTP server IP address, the date and time is synchronized with the network and the wizard
completes. If you do not enter an NTP server IP address, the wizard prompts you for the current date and
time information.
NTP Server IP Address? [A.B.C.D]
Date (mm/dd/yyyy)? [02/05/2002]
Time (hh:mm:ss)? [16:42:38] 10:42:12
Date and time are now configured.
Done with setup.