System information

12-338
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup
setup
To configure the SN 5428-2 Storage Router using the setup configuration wizard, use the setup
command. The Setup configuration wizard runs the Management Interface, Date and Time, Network
Management, Management Access, and SCSI routing (if applicable) individual wizards in sequence.
setup
Syntax Description This command has no arguments or keywords.
Defaults For multiple choice questions, the system presents the choices enclosed in brackets, []. Each multiple
choice question has a default answer that is selected when you press Enter or Return. The default is
shown in parentheses, (). For example:
Enable High Availability? [yes/no (no)]
For configuration variables, the current value saved in the system is presented in brackets. For example:
Network mask ? [255.255.255.0]
If the configuration variable does not have a value, the system will present a set of “empty” brackets,
[(empty)], or a template that provides the required format of the value. For example:
SN5428-2 system name? [(empty)]
Command Modes Administrator.
Command History
Usage Guidelines Initial system configuration and subsequent reconfiguration can be performed via interactive
configuration wizards through the console interface (or via Telnet or SSH once the management interface
has been configured). The configuration wizards prompt you for the necessary information to
accomplish the specific configuration task and may invoke multiple commands to complete their
functions.
The CLI provides the following configuration wizards:
• Setup—runs the Management Interface, Date and Time, Network Management, Management
Access, and SCSI routing (if applicable) individual wizards in sequence.
• Management Interface—configures the management interface with a system name, IP address, and
optional DNS server information.
• Date and Time—configures the time zone, use (or non-use) of daylight savings time, and the NTP
server address (if one is present) or the current date and time.
• Network Management—configures the use of Telnet, web-based GUI, and SNMP for managing the
storage router over the network.
Release Modification
3.2.1 This command was introduced.