System information

12-323
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
scsirouter target lun serial
Use the force keyword to allow mapping of the same storage array control LUN in multiple targets. Do
not use the force keyword to LUN-map the same data LUN in multiple targets. LUN-mapping of the
same LUN in multiple targets is advised for a control LUN on a storage controller only.
Examples The following example maps the logical target and LUN combination for SCSI routing instance lab2.
The logical target and LUN combination, webserver9 LUN 1, is mapped to the physical LUN with a
serial number of ST318451FC3CC05T3N00007116DLWQ.
[SN5428-2A]# scsirouter lab2 target webserver9 lun 1 serial ST318451FC3CC05T3N00007116DLWQ
Related Commands Command Description
accesslist Create an access list entity.
accesslist A.B.C.D/bits Add IP addresses to an access list.
accesslist
chap-username
Add CHAP user name entries to an access list.
accesslist iscsi-name Add iSCSI Name entries to an access list.
delete accesslist Delete a specific access list entry or an entire access list.
delete scsirouter Delete the named SCSI routing instance or the specified element of the
SCSI routing instance.
restore accesslist Restore the named access list or all access lists from the named
configuration file.
restore scsirouter Restore the named SCSI routing instance from the named configuration file.
save accesslist Save configuration data for the named access list or all access lists.
save scsirouter Save configuration information for the named SCSI routing instance.
scsirouter Create a SCSI routing instance.
scsirouter enable Stop or start the named SCSI routing instance.
scsirouter primary Identify a storage router as the preferred storage router to run the named
SCSI routing instance.
scsirouter serverif Assign a Gigabit Ethernet interface, IP address, and optionally a VLAN to
the named SCSI routing instance.
scsirouter target
accesslist
Associate an access list with a specific SCSI routing instance target or all
targets.
scsirouter target
enable
Allow or disallow connections and logins for the named target.
setup scsi Run the wizard to configure a SCSI routing instance.
show accesslist Display the contents of the named access list or all access lists.
show scsirouter Display configuration and operational information for the named SCSI
routing instance.