System information

12-246
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
reboot
reboot
To cause the SN 5428-2 Storage Router to shut down and then restart, issue the reboot command.
Note Rebooting may cause the storage router to run a different version of software. See the software version
command for details.
reboot [force] [fast]
Syntax Description
Defaults If there are unsaved configuration changes when the command is issued, the default is to save all changes
before rebooting. If the command is issued with the optional force keyword, any unsaved configuration
changes are discarded.
Command Modes Administrator.
Command History
Usage Guidelines If the storage router is participating in a cluster, the reboot command will cause any SCSI routing
instances running on this storage router to failover to another node in the cluster. At restart, the cluster
determines any SCSI routing instances that should start on the storage router. If the SN 5428-2 is
identified as the preferred storage router for any SCSI routing instance (via the scsirouter primary
command), that instance will start running on the SN 5428-2 (assuming targets and critical resources are
available).
If the reboot command is issued with no keywords and there are unsaved changes to the current
configuration, you can choose to either save all changes or reboot without saving any changes.
Use the force keyword to cause an immediate reboot of the storage router, discarding any unsaved
configuration changes. Append the optional fast keyword to bypass diagnostics during the reboot
sequence.
fast (Optional) Force a soft reboot of the storage router, bypassing hardware
diagnostics.
force (Optional) Force an immediate reboot of the storage router.
Release Modification
3.2.1 This command was introduced.