System information

12-223
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
logging on
logging on
To enable logging of SN 5428-2 Storage Router event messages based on the rules in the logging table,
use the logging on command. To temporarily disable logging of all event messages, use the no form of
this command.
logging on
no logging on
Syntax Description This command has no arguments or keywords.
Defaults Logging is enabled by default. The factory default logging rules are as follows:
• All messages from all facilities at notice level or lower levels are logged to all destinations.
• All messages from all facilities at info level or lower levels are logged to the storage router log file.
• All messages from all facilities at debug level are not logged.
Command Modes Administrator.
Command History
Usage Guidelines Use the no form of this command to quickly disable logging of all messages. For example, if there is an
error condition that is overwhelming the console with messages, enter no logging on to temporarily
disable logging without changing the logging table. Use the logging on command to re-enable logging
when the problem is resolved.
Examples The following example temporarily disables logging of all event messages:
[SN5428-2A]# no logging on
Release Modification
3.2.1 This command was introduced.