System information

12-181

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

interface fc? reset

To disable and then enable the specified Fibre Channel (FC) interface, use the interface fc? reset

command.

interface fc? reset

Syntax Description

Defaults None.

Command Modes Administrator.

Command History

Usage Guidelines This command is functionally equivalent to issuing a no interface fc? enable command, followed by an

interface fc? enable command.

After placing the FC interface into diagnostic mode and performing internal loopback testing, use this

command to return the interface to an operational state.

Examples The following example resets the FC interface named fc3:

[SN5428-2A]# interface fc3 reset

Related Commands

fc? The name of the FC interface for which you are setting this parameter. Valid

values are fc1 through fc8. When you type the interface fc? command, the

CLI lists the interfaces available. You cannot specify a nonexistent

interface.

Release Modification

3.2.1 This command was introduced.

Command Description

interface fc? diag Set the named FC interface into diagnostic mode for testing purposes.

interface fc? enable Enable the named FC interface.

interface fc? loopback Initiate a loopback test on the named FC interface.