Specifications

CHAPTER
6-1
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
6
Configuring SCSI Routing
This chapter explains how to configure your SN 5428-2 Storage Router for SCSI routing and contains
the following sections:
• Prerequisite Tasks, page 6-1
• Configuration Tasks, page 6-2
• Creating a SCSI Routing Instance, page 6-6
• Configuring a Server Interface, page 6-6
• Configuring iSCSI Targets, page 6-7
• Creating and Configuring an Access List, page 6-10
• Configuring Access to iSCSI Targets, page 6-11
• Verifying and Saving Configuration, page 6-14
SCSI routing can be configured using CLI commands, as described in this chapter, or via the web-based
GUI. To access the web-based GUI, point your browser to the storage router’s management interface IP
address. After logging on, click the Help link to access online help for the GUI.
Prerequisite Tasks
Before configuring SCSI routing, make sure you have configured all system parameters as described in
Chapter 2, “First-Time Configuration,” or Chapter 3, “Configuring System Parameters.”
If the VLAN service is to be used with the SN 5428-2 Storage Router, configure VLANs as described in
Chapter 4, “Configuring for VLAN,” before proceeding.