Specifications

5-9
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 5 Configuring Fibre Channel Interfaces
Verifying Configuration
Clearing the fabric wide zoning database
When reconfiguring the zones in the FC zoned fabric you must clear the zoning database and deactivate
the active zone set for the entire switched fabric.
Use the following procedure to clear the local zoning database and deactivate the active zone set on the
fabric.
Verifying Configuration
Verify zoning is operational using the following procedure.
Example 5-4 Verifying Zone Operation
[SN5428-2A]# show devices
Fabric Attached Devices detected
Interface WWPN PortId Device Type Lun Lunid Type Lund
--------- ---------------- -------- ------------ ---- ------------- -----
fc1 22000003be3203bc 0x101e2 DASD 0 IEEE Extended 200f
fc1 2200001026448a0d 0x101e1 DASD 0 IEEE Extended 200b
Lun Description Table
Interface WWPN Lun Capacity Vendor Product Serial
--------- ---------------- ----- -------- ------------ ------------ ------
fc1 22000003be3203bc 0 17GB SEAGATE T207341EB 3EVON6B3000M
fc1 2200001026448a0d 0 17GB SEAGATE ST207340EB 3EVON4CW0002
Command Description
Step 1
enable Enter Administrator mode.
Step 2
clear fcswitch zones fabric Clear the local zoning database and deactivate the active zone set
for the entire switched fabric.
Command Description
Step 1
enable Enter Administrator mode.
Step 2
show devices Display all attached devices to the SN 5428-2 (Example 5-4).
Note The show devices command displays an interface number
for each device directly attached to that FC interface. If an
interface number is not displayed, the associated device is
not directly connected to an FC interface; the device is
connected in the FC fabric.