Specifications

12-552
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
telnet enable
telnet enable
To enable Telnet for the SN 5428-2 Storage Router and to start the Telnet server, use the telnet enable
command. To disable Telnet and stop the Telnet server, use the no form of this command.
telnet enable
no telnet enable
Syntax Description This command has no arguments or keywords.
Defaults Telnet is enabled and the Telnet server is started by default.
Command Modes Administrator.
Command History
Usage Guidelines Use this command to enable Telnet for the storage router and start the Telnet server.
If Telnet is enabled and the Telnet server is running, you can still restrict Telnet access to the storage
router for specific interfaces by using the restrict command.
Examples The following example disables Telnet and stops the Telnet server:
[SN5428-2A]# no telnet enable
The following example enables Telnet and starts the Telnet server:
[SN5428-2A]# telnet enable
Related Commands
Release Modification
3.2.1 This command was introduced.
Command Description
restrict Secure access to storage router interfaces by communications protocols and
services.
show telnet Display the status of the Telnet server.