Specifications

4-2

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 4 Configuring for VLAN

Configuration Tasks

VLAN and VTP configuration information applies to all storage routers participating in a cluster. When

the configuration information is saved, the settings become active on all storage routers in the cluster.

Note Changes to cluster-wide configuration elements are handled by a single storage router in the cluster. In

a cluster environment, use the show cluster command to verify that the SN 5428-2 that you are

configuring is managing cluster-wide configuration elements.

To configure for VLAN on the SN 5428-2 Storage Router, perform the following steps:

Step 1 Configure for VLAN using the VLAN Trunking Protocol (VTP).

Configure for VLAN without using VTP.

Step 2 Configure an IP route.

Step 3 Verify and save configuration.

Note You can verify and save the configuration at any point in the process of performing the

configuration tasks. Save your configuration by using the save all bootconfig CLI command.

This command saves all configuration data to the bootable configuration, which is then used

when the storage router is rebooted.

Step 4 Proceed to Chapter 6, “Configuring SCSI Routing,” to configure SCSI routing and to assign a VLAN to

a SCSI routing instance.

Figure 4-1 contrasts configuring the SN 5428-2 Storage Router for VLAN with VTP and without VTP.