Specifications

3-10
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 3 Configuring System Parameters
Verifying and Saving Configuration
Example 3-1 Results of “show ssh” Command
[SN5428-2A]# show ssh
SSH Server Configuration
Status: enabled
Verifying and Saving Configuration
Verify the system parameters using the following procedure. You can save the configuration at any time
using either the save all bootconfig commands. You must save the running configuration to the bootable
configuration for it to be retained in the storage router when it is rebooted.
Use the following procedure to verify configuration information.
Step 7
restrict mgmt telnet (Optional) If SSH is being used as a replacement for Telnet, you
can disable Telnet access through the specified SN 5428-2
interface (or all interfaces). For example, disable Telnet access via
the management interface.
Step 8
no telnet enable (Optional) You can also disable Telnet for the entire SN 5428-2 by
stopping the Telnet service.
Step 9
save system bootconfig Save changes to the SN 5428-2 bootable configuration.
Command Description
Command Description
Step 1
enable Enter Administrator mode.
Step 2
show system Display system information, such as system name, software
version, date and time (including time zone), NTP server, DNS
(name server), and management and HA interface IP addresses.
Step 3
show ip route (Optional) Display the system route table, if you added any routing
information or if you enabled the storage router for RIP listening.
Step 4
show ip rip (Optional) Display RIP configuration and operational information,
if set.
Step 5
show snmp (Optional) Display SNMP management configuration information
for the storage router, if set.
Step 6
show admin (Optional) Display contact information for the system
administrator of the storage router, if set.
Step 7
show ssh (Optional) Display SSH operational status, if configured.
Step 8
show ssh fingerprint (Optional) Display public key information for the SSH, if set.
Step 9
show restrict (Optional) Display the restrict settings, if you made changes to the
protocols allowed for the various SN 5428-2 interfaces.
Step 10
show bootconfig (Optional) Display the current boot configuration of the
SN 5428-2.
Step 11
show runningconfig (Optional) Display the current running configuration of the
SN 5428-2.