Specifications

3-3
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 3 Configuring System Parameters
Configuring the Management Interface
Figure 3-1 System Parameters Example Configuration
Configuring the Management Interface
Configuring the management interface consists of tasks for setting the system name, IP address and
mask, gateway, and DNS servers. Use the following procedure to configure the management interface.
If you want external servers, such as RADIUS, TACACS+ or SMTP servers, to communicate with the
SN 5428-2 Storage Router via a specific IP address on a Gigabit Ethernet interface (for in-band
management), configure the IP address on the desired Gigabit Ethernet interface, as described in Step 4.
Save the changes to the bootable configuration (save all bootconfig), and then reboot the storage router.
Note The purpose of Figure 3-1 is an example system configuration only. The IP addresses and all names
given below are examples only.
Gateway
IP: 10.1.10.201
Primary DNS server
IP: 10.1.40.243
Secondary DNS server
IP: 10.1.50.249
Management Station
IP: 10.1.30.17
NTP server
IP: 10.1.60.86
Cisco SN 5428-2
Cisco SN 5428
ManagementHA
GEx
85735
GEx interface
GE1 primary management interface
GE2 secondary management interface
IP: 10.1.70.85
Mask: 255.255.255.0
Management interface
System Name: SN_5428-MG1
Domain Name: mystoragenet.com
IP: 10.1.10.244
Mask: 255.255.255.0
HA interface
Cluster Name: Mt_Olympus
IP: 10.1.20.56
Mask: 255.255.255.0
Command Description
Step 1
enable Enter Administrator mode.
Step 2
hostname SN_5428-2-MG1 Specify or change the system name. The system name identifies
the SN 5428-2 through the management interface and appears
immediately in the prompt.