Specifications

2-14
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Where to Go Next
Where to Go Next
Note If you want to configure a high availability cluster, or add the storage router to an existing cluster, review
the information and procedures in Chapter 10, “Configuring a High Availability Cluster,” before
configuring additional system parameters or SCSI routing.
If you did not run the complete SN 5428-2 setup configuration wizard, or if you want to make system
configuration additions, changes, or corrections, continue with the procedures described in Chapter 3,
“Configuring System Parameters.”
If you are using the VLAN service with the storage router and you entered all desired
parameters—except for SCSI routing—with the setup configuration wizard (see “Running the Setup
Configuration Wizard” section on page 2-8 for details), configure for VLAN using the procedures
described in Chapter 4, “Configuring for VLAN.”
If you are participating in Fibre Channel switched fabric zoning with the storage router, configure for
zoning using the procedures described in Chapter 5, “Configuring Fibre Channel Interfaces.”
If you do not need to configure for VLAN or zoning, go directly to Chapter 6, “Configuring SCSI
Routing,” to configure SCSI routing more extensively or Chapter 7, “Configuring Transparent SCSI
Routing,” to verify the configuration of an SN 5428-2 deployed for transparent SCSI routing.
If you need to configure FCIP, go to Chapter 8, “Configuring FCIP.”