Specifications

2-12
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Introducing the Web-Based GUI
Starting a CLI Management Session
Follow these steps to start a CLI management session via a Telnet connection to the storage router.
Step 1 Establish a Telnet session to the SN 5428-2.
Step 2 Enter the appropriate password at the logon prompt.
Step 3 (Optional) Enter enable to change to Administrator mode.
Note If you need to make changes to the configuration of the storage router, you need to enable the
Administrator mode.
Step 4 (Optional) Enter the Administrator password at the prompt.
Step 5 Issue the appropriate CLI commands to complete the desired task.
Introducing the Web-Based GUI
If the SN 5428-2 is deployed for SCSI routing, you can also configure the SN 5428-2 Storage Router
using the web-based GUI. You can use the GUI for configuration after completing the initial system
configuration script, which assures that the SN 5428-2 management interface is configured with an IP
address.
To access the GUI, enter the URL for the SN 5428-2 by pointing your browser to the SN 5428-2
management interface IP address using the HTTP protocol (for example, type http://10.1.10.244).
Logging In
After entering the URL for the SN 5428-2, a login page appears. You can log in as monitor or as admin,
entering the appropriate user name and password in the dialog box that appears. See Table 2-5 for the
user name and factory default password to use for the two login options.
Note If you configured new passwords using the setup wizard, or if the SN 5428-2 joined an existing cluster
with different passwords, use them when logging in.
Table 2-5 Logging into Web-Based GUI
Login Options User Name Factory Default Password
Monitor monitor cisco
Admin admin cisco