Specifications

12-361
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup time
setup time
To set current date and time information and other time-related configuration settings, use the
setup time configuration wizard. The storage router uses date and time information for log files and the
user interface.
setup time [parameter1 parameter2...]
Syntax Description
Defaults Defaults or current values are shown in parentheses within the allowable response brackets. In the
following example, the current date is 02/05/2002.
Date (mm/dd/yyyy)? [02/05/2002]
Command Modes Administrator.
Command History
Usage Guidelines The wizard prompts you to enter the appropriate time zone (as an offset from Universal/GMT). You can
also enter an optional IP address of an NTP server, to be used by the storage router for date and time
synchronization. If no NTP server address is provided, the wizard prompts you for the current date and
time.
Only one setup wizard can be active at any given time. Multiple users cannot run multiple setup wizards
concurrently.
Use the optional parameter arguments to run the setup time wizard from a command script. All
parameters required by the wizard must be included. The setup time wizard will not complete unless all
parameters are passed.
Note If too many parameters are passed, the setup time wizard will ignore the extra parameters and may
complete. If a parameter is not in the correct format or is otherwise invalid, the next parameter is used
to attempt to fulfill the prompt. In either case, unexpected results could occur. Always check the output
from a setup time command when using the parameter arguments.
parameter1 parameter2
...
(Optional) Enter each parameter that the wizard prompts for. All parameters
must be passed. If a parameter includes an embedded space, enclose the
parameter in quotation marks.
Release Modification
3.2.1 This command was introduced.