Specifications

12-358

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

setup scsi

To configure a SCSI routing instance, use the setup scsi configuration wizard. The wizard prompts you

to enter the name of the SCSI routing instance (maximum 32 characters) and to specify the IP address

and Gigabit Ethernet interface for the SCSI routing instance. Then the wizard discovers all Fibre

Channel devices connected to the SN 5428-2 Storage Router. More extensive configuration of SCSI

routing instances can be performed via the CLI or the web-based GUI.

setup scsi [parameter1 parameter2...]

Syntax Description

Defaults Defaults or current values are shown in parentheses within the allowable response brackets. In the

following example, the current default Gigabit Ethernet interface is ge1.

Scsirouter instance GE interface ? [ge1|ge2 (ge1)]

Command Modes Administrator.

Command History

Usage Guidelines After the wizard finishes the discovery process, it displays a list of accessible storage resources. Targets

can be explicitly added by using the web-based GUI or CLI commands.

The setup scsi command can only be run when no SCSI routing instance is currently configured on the

storage router. Only one setup wizard can be active at any given time. Multiple users cannot run multiple

setup wizards concurrently.

Use the optional parameter arguments to run the setup scsi wizard from a command script. All

parameters required by the wizard must be included. The setup scsi wizard will not complete unless all

parameters are passed.

Note If too many parameters are passed, the setup scsi wizard will ignore the extra parameters and may

complete. If a parameter is not in the correct format or is otherwise invalid, the next parameter is used

to attempt to fulfill the prompt. In either case, unexpected results could occur. Always check the output

from a setup scsi command when using the parameter arguments.

parameter1 parameter2

...

(Optional) Enter each parameter that the wizard prompts for. All parameters

must be passed. If a parameter includes an embedded space, enclose the

parameter in quotation marks.

Release Modification

3.2.1 This command was introduced.