Specifications

12-354
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup mgmt
Examples The following shows example output for the setup mgmt command:
[SN5428-2A]# setup mgmt
################################
## Management Interface Setup ##
################################
Please choose a name for the SN5428-2. This name is associated with the
SN5428-2 Management Interface IP address. If you wish to enable network
management on the SN5428-2, you should add the system name you provide
at this prompt and its IP address to a domain name server (nis, nis+, WINS).
SN5428-2 system name? [SN5428-2A]
The SN5428-2 may be managed using telnet, or a web-based GUI, or SNMP via the
10/100 Ethernet interface labeled "mgmt" on the front panel of the system. This
interface must be assigned an IP address.
Management Interface IP address? [10.1.12.122/24]
If the SN5428-2 is to be managed from a subnet other than the one to which it
is physically attached, a static route is required. The static route format
is "destination/netmask gateway".
Static route for Management Interface? [0.0.0.0/0 10.1.12.1]
If IP addresses are to be entered as host names via any of the SN5428-2
management interfaces, a Domain Name Server must be specified. A secondary
DNS may be specified for use if the primary DNS is not available.
Primary DNS Server? [A.B.C.D]
Secondary DNS Server? [A.B.C.D]
Setting up the management interface ... Done
The management port is now operational. It may be tested using ping
or telnet from a host on the network.
Done with setup.
Related Commands Command Description
clear conf Return most configuration settings to factory defaults.
setup Run the setup configuration wizard.
setup access Run the wizard to configure Monitor mode and Administrator mode
passwords.
setup cluster Change the configuration of the high availability environment.
setup fcip Run the wizard to manually configure FCIP instances.
setup iscsi-port Run the wizard to manually configure the port used for iSCSI traffic.
setup netmgmt Run the wizard to configure network management.
setup scsi Run the wizard to configure a SCSI routing instance.
setup time Run the wizard to configure the system date and time.