Specifications

12-353
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup mgmt
setup mgmt
To configure the SN 5428-2 Storage Router management interface, use the setup mgmt configuration
wizard. The wizard prompts you to enter the system name, management interface IP address and subnet
mask, optional default gateway and DNS information.
setup mgmt [parameter1 parameter2...]
Syntax Description
Defaults Defaults or current values are shown in parentheses within the allowable response brackets. In the
following example, the current system name is SN5428-2_Lab1.
SN5428-2 system name? [SN5428-2_Lab1]
Command Modes Administrator.
Command History
Usage Guidelines The management interface must be configured before the Telnet interface or web-based GUI can be used
for configuration or monitoring tasks. When the wizard is completed, the system displays notification
that the management interface is operational.
Only one setup wizard can be active at any given time. Multiple users cannot run multiple setup wizards
concurrently.
Use the optional parameter arguments to run the setup mgmt wizard from a command script. All
parameters required by the wizard must be included. The setup mgmt wizard will not complete unless
all parameters are passed.
Note If too many parameters are passed, the setup mgmt wizard will ignore the extra parameters and may
complete. If a parameter is not in the correct format or is otherwise invalid, the next parameter is used
to attempt to fulfill the prompt. In either case, unexpected results could occur. Always check the output
from a setup mgmt command when using the parameter arguments.
parameter1 parameter2
...
(Optional) Enter each parameter that the wizard prompts for. All parameters
must be passed. If a parameter includes an embedded space, enclose the
parameter in quotation marks.
Release Modification
3.2.1 This command was introduced.