Specifications

12-346
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
setup cluster
If you select HA configuration mode clustered, the wizard prompts you to enter an HA IP address:
To determine the health of other SN5428-2s in a cluster, the SN5428-2 must send
occasional heartbeat packets on at least two interfaces (in case one interface
has problems). By default, the interfaces used are the 10/100 management
interface (already set up) and the 10/100 HA interface. Please select an IP
address and network mask for the HA interface.
HA Interface IP address? [10.1.40.230/24]
After selecting the HA configuration mode, and optionally setting the HA IP address, the wizard prompts
you to enter a cluster name:
When you change the cluster that the SN5428-2 belongs to, you need to
decide if you want the scsirouter instances running on the SN5428-2 to be
deleted or if you want them to be retained and merged with the new cluster.
Change cluster to ? [Cluster1]
For a change from standalone to clustered:
If you retain the configuration, there may be conflicts when the
scsirouter instances are replicated between this SN5428-2 and others in the
new cluster.
For a change from clustered to standalone:
You can retain the configuration without causing any scsirouter instance
conflicts for this SN5428-2 since it will be the only member of the
new cluster.
Retain or delete scsirouter instances ? [retain/delete (delete)] retain
If you choose to retain the existing SCSI routing instance configurations, an additional warning displays:
#########################################################
Please confirm that you want to retain the configuration.
#########################################################
All configuration settings will be saved.
The system will REBOOT if you answer "yes"
** Enter CTRL-C to cancel. **
Are you sure you want to retain the configuration ? [must type "yes"] yes
If you choose to delete your existing configuration, this warning displays:
Retain or delete applications ? [retain/delete (delete)] delete
#########################################################
Please confirm that you want to delete the configuration.
#########################################################
Cluster configuration settings will be saved.
The system will REBOOT if you answer "yes"
** Enter CTRL-C to cancel and abort the cluster change. **
Are you sure you want to delete the configuration ? [must type "yes"] yes
After confirming your selection, the storage router automatically reboots.