Specifications

12-341

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

setup access

To configure passwords for monitoring and administering the SN 5428-2 Storage Router, use the

setup access configuration wizard. The wizard prompts you to enter and confirm new passwords.

setup access [parameter1 parameter2...]

Syntax Description

Defaults The factory default password for both Administrator mode and Monitor mode is cisco.

Command Modes Administrator.

Command History

Usage Guidelines The wizard prompts you to enter (and confirm by re-entering) the new Monitor password, which allows

view-only access to the storage router. It also prompts you to enter (and confirm by re-entering) the new

Administrator password, which allows changes to be made to the storage router configuration.

Passwords are cluster configuration elements. In a high availability (HA) cluster, the setup access

wizard can only be run from the storage router that is currently performing password management

functions.

Only one setup wizard can be active at any given time. Multiple users cannot run multiple setup wizards

concurrently.

Use the optional parameter arguments to run the setup access wizard from a command script. All

parameters required by the wizard must be included. The setup access wizard will not complete unless

all parameters are passed.

Note If too many parameters are passed, the setup access wizard will ignore the extra parameters and may

complete. If a parameter is not in the correct format or is otherwise invalid, the next parameter is used

to attempt to fulfill the prompt. In either case, unexpected results could occur. Always check the output

from a setup access command when using the parameter arguments.

parameter1 parameter2

...

(Optional) Enter each parameter that the wizard prompts for. All parameters

must be passed. If a parameter includes an embedded space, enclose the

parameter in quotation marks.

Release Modification

3.2.1 This command was introduced.