Specifications

2-9
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Running the Setup Configuration Wizard
Use the following procedure to start the setup configuration wizard.
If you configured any interfaces or identified any servers to the SN 5428-2 that are outside the storage
router management subnet, you must update the SN 5428-2 route table with the appropriate gateways
that will provide access to these interfaces or servers, or configure the SN 5428-2 for RIP listening to
dynamically learn IP routes. See Chapter 3, “Configuring System Parameters,” for details on adding
static IP routes or configuring the SN 5428-2 for RIP listening.
You can use the setup command again to change these basic configuration parameters. You can also use
the CLI or, if the storage router is deployed for SCSI routing, the web-based GUI to make changes to the
basic storage router configuration or to configure the storage router more extensively. To access the
web-based GUI, point your browser to the SN 5428-2 management interface IP address.
Command Description
Step 1
enable Enter Administrator mode. If prompted for an Administrator
password, use the default password, cisco.
Note Passwords are cluster-wide configuration elements and
apply to all storage routers in a cluster. If the SN 5428-2
joined an existing cluster during initial configuration,
enter the Administrator mode password already configured
for the cluster.
Step 2
setup Start the setup configuration wizard.
The wizard will ask you to choose one of the two levels:
• The novice level provides information before the prompt
explaining what is being requested.
• The expert level does not provide the explanatory text.
Respond to the prompts using your First-Time Configuration
Checklist.
• For multiple choice questions, the choices are shown in square
brackets.
• For values requiring a specific format, the required format is
shown in square brackets.
• If values have already been entered (for instance, via the
initial system configuration script), the current value saved in
the system are shown in square brackets.
• Default values are shown in parentheses within the square
brackets.
• If you want to accept the current or default value, press Enter.
• If there is no default and you want to bypass the question (that
is, you do not want to change or provide a value), press Enter.