Specifications

2-8

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 2 First-Time Configuration

Running the Setup Configuration Wizard

The setup configuration wizard is available from the CLI and is a script that consists of a series of

prompts asking you to enter values to provide a basic system configuration for your SN 5428-2. You will

be asked to enter values to configure the following:

• Management interfaces (including primary and secondary DNS servers)

• Date and time (including time zone and NTP server)

• Network management access (including SNMP)

• Management access (including passwords and system administrator contact information)

• SCSI routing (this section of the wizard only appears if SCSI routing was the configuration

deployment selected in the initial system configuration script; if you are using the VLAN service,

do not configure SCSI routing with the setup configuration wizard)

• FCIP (this section of the wizard only appears if FCIP was the configuration deployment selected in

the initial system configuration script)

You can run the setup configuration wizard through an EIA/TIA-232 console interface connection, or

through a Telnet session using the management interface.

The values entered for the setup configuration wizard are saved at the end of the wizard’s script. To quit

the configuration wizard at any time without saving changes, press Ctrl-C, and reboot the storage router

to restore previous values.

Note The factory default listening port used for iSCSI traffic is 3260. This is a port number assigned by IANA.

You can change this value for your network configuration if needed. See the CLI setup iscsi-port

command in Chapter 12, “Command Line Interface Reference,” for details.