Specifications

2-7
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Initial System Configuration Script
Initial System Configuration Script
The initial system configuration script runs on the CLI and ensures that a few required values are entered
to make the SN 5428-2 Storage Router operational. When you first power up the storage router and after
the initial boot process, the script will run automatically on the CLI session running on the terminal
emulation program via an EIA/TIA-232 console connection.
After the first running of the script, the script will run automatically whenever the storage router is not
configured with an IP address for the management interface, due most likely to a clear conf command,
which requires the system to be configured again.
The initial system configuration script provides explanatory text before prompting you to enter
configuration values. There are two versions of the script. The values asked for by the script are
determined by the configuration deployment option entered for the first prompt.
Table 2-3 lists the configuration items in the order they will appear in the script.
When the script completes, the system will automatically reboot. When the command prompt returns,
continue configuration with the setup configuration wizard.
Table 2-3 Configuration Items in Initial System Configuration Script
Configuration Item Configuration Deployment
Configuration deployment option: 1 for SCSI routing, 2 for
transparent SCSI routing, 3 for FCIP
All
Static or dynamic deployment for transparent SCSI routing Transparent SCSI routing
Management interface IP address and subnet mask in CIDR style (for
example: 10.1.10.244/24)
All
(Optional) The destination IP address with subnet mask and then the
gateway IP address. (for example 1.0.1.0/24 10.0.1.2)
All
SN 5428-2 system name (maximum length allowed is 19 characters) All
HA configuration (standalone or clustered) SCSI routing
Cluster name (asked for only when HA configuration is set to
clustered)
SCSI routing
HA interface IP address and subnet mask in CIDR style (for example:
10.1.20.56/24; asked for only when HA configuration is set to
clustered)
SCSI routing
Multiple or Redundant interfaces (configure a unique Gigabit
Ethernet IP address for each interface, or configure a single Gigabit
Ethernet interface that can be presented on either interface)
Transparent SCSI routing
Gigabit Ethernet IP address and subnet mask in CIDR style (for
example: 10.1.0.45/24; for multiple interfaces, configure a maximum
of one IP address per interface, or for redundant interfaces, configure
one IP address that can be presented on either interface)
Transparent SCSI routing