Specifications

2-6
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Connecting a Console
Once you have completed the first-time configuration checklist, you are ready to continue with the
first-time configuration of the SN 5428-2 Storage Router using the initial system configuration script
and the setup configuration wizard.
Connecting a Console
To begin configuration of your SN 5428-2 Storage Router, use the CLI by connecting a PC with a
terminal emulation program to the EIA/TIA-232 console interface according to the Cisco SN 5428-2
Storage Router Hardware Installation Guide. Then make sure that the terminal emulation program is
configured for a CLI session with the values provided in Table 2-2.
IP address A Gigabit Ethernet interface and IP address for the
named FCIP instance, to provide IP connectivity
between the FCIP instance and its peer
destination.
Required for FCIP
only
Peer address The IP address of the FCIP peer destination. Required for FCIP
only
Protocol type Protocol to assign to the FCIP peer destination,
determined as follows:
• If the peer is configured as a TCP client,
assign protocol tcpserver
• If the peer FCIP instance is configured as a
TCP server, assign protocol tcpclient.
• If the peer FCIP instance is configured to use
raw IP, assign protocol raw
Required for FCIP
only
Domain ID Set the domain IDs of the FCIP peers to different
values, to avoid conflict.
Required for FCIP
only
Table 2-1 First-Time Configuration Checklist (continued)
Configuration Item Description Required or Optional
Your Configuration
Value
Table 2-2 Terminal Emulation Configuration
Setting Value
Bits Per Second 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None