Specifications

2-5
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 2 First-Time Configuration
Collecting Configuration Information
Monitor-level password A password for users who will only monitor
storage router operations. The default password is
cisco.
Optional
Administrator-level
password
A password for users who will configure and
administer the storage router. The default
password is cisco.
Optional
Password applied to
EIA/TIA-232 console
interface
Choose whether or not the user is required to enter
the monitor and administrator password when
accessing the storage router via the EIA/TIA-232
console interface. The default is no.
Optional Yes or no
Site-specific contact
information for the
SN 5428-2.system
administrator
Name Optional
E-mail Address Optional
Phone number Optional
Pager Number Optional
Name of SCSI routing
instance
A unique name for a SCSI routing instance.
Names of instances can be up to 32 characters in
length. A maximum of 12 unique SCSI routing
instances are allowed. Only one instance can be
named in the setup configuration wizard.
Note Do not name the SCSI routing instance
with the setup configuration wizard if you
are using the VLAN service with your
SN 5428-2. See Chapter 4, “Configuring
for VLAN,” before naming and
configuring SCSI routing instances.
Required for SCSI
routing only
Gigabit Ethernet
interface and IP address
and subnet mask
Associate the Gigabit Ethernet interface (ge1 or
ge2) and IP address to the SCSI routing instance.
IP hosts access FC storage using this address.
Required for SCSI
routing only
Multiple or redundant
Gigabit Ethernet
interfaces, IP addresses
and subnet masks
Configure multiple or redundant Gigabit Ethernet
interfaces for the SCSI routing instance. IP hosts
access FC storage using these addresses.
For transparent SCSI routing, configure a
maximum of one IP address per Gigabit Ethernet
interface (multiple interfaces) or configure one IP
address that can be presented on either interface
(redundant interfaces).
If you configure the Gigabit Ethernet interfaces
(ge1 and ge2) as redundant, they must be
connected to the same network segment.
Required for
transparent SCSI
routing only
FCIP instance name The name of the FCIP instance. Valid names are
fcip1 and fcip2.
Required for FCIP
only
fcip2 or fcip2
Table 2-1 First-Time Configuration Checklist (continued)
Configuration Item Description Required or Optional
Your Configuration
Value