Specifications

1-24
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 1 Before Configuring SN 5428-2 Storage Router Software
Where to Go Next
Figure 1-22 SN 5428-2 Chassis-Slot Numbering
Where to Go Next
When you are ready to configure the SN 5428-2 software, proceed to one of the following chapters in
this configuration guide according to your needs:
• Chapter 2, “First-Time Configuration”—For initial setup or after configuration has been reset to
factory default configuration
• Chapter 3, “Configuring System Parameters”—Using the CLI for setting up and modifying system
parameters
• Chapter 4, “Configuring for VLAN”—Using the CLI for setting up and modifying VLAN
configurations
• Chapter 5, “Configuring Fibre Channel Interfaces”—Using the CLI for setting up and modifying FC
interface and zoning configurations
• Chapter 6, “Configuring SCSI Routing” —Using the CLI for setting up and modifying SCSI routing
configurations
• Chapter 7, “Configuring Transparent SCSI Routing” —Using the CLI for setting up and modifying
transparent SCSI routing configurations
• Chapter 8, “Configuring FCIP” —Using the CLI for setting up and modifying FCIP configurations
• Chapter 9, “Configuring Authentication”—Using the CLI for setting up and modifying
authentication configurations
• Chapter 10, “Configuring a High Availability Cluster”—Using the CLI for setting up and modifying
cluster configurations
• Chapter 11, “Maintaining and Managing the SN 5428-2 Storage Router”—Downloading software,
backing up and restoring configurations, and other related maintenance and management tasks
• Chapter 12, “Command Line Interface Reference”—For a basic understanding of the command line
interface and information on all CLI commands.
Note This guide does not describe how to configure iSCSI drivers. Install and configure iSCSI drivers
according to readme and example configuration files for each driver.
85739
ge1 ge2 fc1 fc2 fc3 fc4 fc5 fc6 fc7 fc8