Specifications

12-197

Cisco SN 5428-2 Storage Router Software Configuration Guide

78-15471-01

Chapter 12 Command Line Interface Reference

interface mgmt

To set various operational parameters associated with the management interface, such as the speed and

duplex mode, use the interface mgmt command.

interface mgmt autonegotiation

interface mgmt no autonegotiation [speed {10 | 100}] [duplex {full | half}]

Syntax Description

Defaults Auto negotiation is enabled.

Command Modes Administrator.

Command History

Usage Guidelines Use this command to manually set a specific interface speed and duplex setting, if the partner is unable

to auto negotiate these settings.

All storage routers in a cluster should be configured with the same interface-specific parameters,

allowing failover to provide consistent performance characteristics. Use the show interface mgmt

command to display current operating characteristics for the management interface.

Examples The following example disables auto negotiation, and sets the interface speed to 10 Mbps, duplex full:

[SN5428-2A] interface mgmt no autonegotiation speed 10 duplex full

autonegotiation Auto negotiation will always be used on this interface. Operational

characteristics will automatically be negotiated with the partner.

speed 10 (Optional) The interface speed is fixed at 10 Mbps. Auto negotiation is not

used.

speed 100 (Optional) The interface speed is fixed at 100 Mbps. Auto negotiation is not

used. If speed is not specified, the default is 100 Mbps.

duplex full (Optional) The duplex setting is fixed at full. Auto negotiation is not used.

If the duplex setting is not specified, the default is full duplex.

duplex half (Optional) The duplex setting is fixed at half. Auto negotiation is not used.

Release Modification

3.2.1 This command was introduced.