Specifications
12-154
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
fcswitch zoning default
fcswitch zoning default
To select the level of communication between the storage router and devices in the fabric when there is
no active zone set, use the fcswitch zoning default command.
fcswitch zoning default {all | none}
Syntax Description
Defaults If there is no active zone set, the storage router can communicate with all switches and other devices in
the fabric, by default.
Command Modes Administrator.
Command History
Usage Guidelines By default, the SN 5428-2 Storage Router can merge into existing FC switched fabric zones and
participate in the zoning. Use this command to isolate the storage router and prevent communication
with any switch or other device in the fabric, if there is no active zone set.
Before changing the default behavior, disconnect any ISL links to other fabric entities to prevent
unintended disruption of fabric traffic.
Examples The following example prevents the storage router from communicating with switches and all other
devices in the fabric, if there is no active zone set:
[SN5428-2A]# fcswitch zoning default none
default all Enables the storage router to communicate with all switches and other
devices in the fabric when there is no active zone set. This is the default.
default none When there is no active zone set, the storage router cannot communicate
with any other switch or device in the fabric.
Release Modification
3.2.1 This command was introduced.