Specifications

12-149
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
fcswitch syslog
fcswitch syslog
To specify the logging parameters for the SN 5428-2 Storage Router integrated Fibre Channel (FC)
switch component system log file, use the fcswitch syslog command.
fcswitch syslog components component1 [component2...]
fcswitch syslog level notification-level
Syntax Description
Defaults All components log information into the SN 5428-2 Storage Router integrated FC switch component
system log, by default. The default notification level is critical.
Command Modes Administrator.
Command History
Usage Guidelines Use this command to limit the amount of information recorded in the switch system log by component
and by notification level. To stop all logging for all components, set the notification level to none.
components
component1
[component2...]
At least one of the components described in Table 12-8.
level notification-level Limit logging to messages of a specified level or lower. See Table 12-9 in
the Usage Guidelines section for a list of valid names that can be used for
the notification-level argument.
Release Modification
3.2.1 This command was introduced.
Table 12-8 fcswitch syslog components
Component Description
Blade Monitors modular circuit boards.
Chassis Monitors chassis hardware components.
Eport Monitors all Fibre Channel interfaces where the
port is operating as an expansion port (E_Port).
NameServer Monitors name server events.
MgmtServer Monitors management server status.
Other Monitors miscellaneous events.
Port Monitors all port events.
Switch Monitors switch management events.
Zoning Monitors zoning conflict events.