Specifications

12-54
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
Chapter 12 Command Line Interface Reference
clear logging table
clear logging table
To clear the SN 5428-2 Storage Router logging table of all entries, or to reset the table to factory
defaults, issue the clear logging table command.
clear logging table [to factory_defaults]
Syntax Description
Defaults None.
Command Modes Administrator.
Command History
Usage Guidelines Use this command to remove all rules for routing storage router event messages. If the logging table is
cleared, logging is still enabled but all messages will be discarded.
To return the logging table to the factory default logging rules, use the to factory_defaults keywords.
The factory default logging rules are as follows:
• All messages from all facilities at notice level or lower levels are logged to all destinations.
• All messages from all facilities at info level of lower levels are logged to the storage router log file.
Examples The following example clears all entries from the storage router logging table and returns the table to
the default logging rules:
[SN5428-2A]# clear logging table to factory_defaults
Related Commands
to factory_defaults Return the storage router logging table to the factory default logging rule
entries.
Release Modification
3.2.1. This command was introduced.
Command Description
delete logging Delete a rule from the logging table.
logging #? Insert a routing rule entry into the storage router logging table.
logging level Add rule entries to route storage router event, debug and trace messages to
various destinations based on facility and notification level.
logging on Enable or temporarily disable logging of storage router event message.
show logging Display the routing rules in the logging table and the contents of the storage
router log file.