Operation Manual

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 29
1
87778
(Cisco
SPA501G)
Restore the phone user settings to the default. (Clears all user settings
such as speed dials.)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668 Reboot the phone. Enter # and hang up to begin rebooting.
111 Set a static IP address. Enter the IP address (use * to enter the decimal
(.)), then press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the decimal (.)), then
press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
131 Set a gateway. Enter the address (use * to enter the decimal (.)), then
press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
161 Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the decimal (.)), then press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
181 Set the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone). Enter the address (use * to enter the
decimal (.)), then press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
7932 Enable or disable the web-based configuration utility. Press 1 to enable
or 0 to disable, then press #.
To s a ve , p r e s s 1; to review, press 2; to re-enter, press
3; to exit, press *.
Number Option
Downloaded from www.Manualslib.com manuals search engine