Operation Manual

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 28
1
- 4—Factory Reset—Restores the phone to the factory default software
and settings. Enter 1 to confirm or * to cancel.
- 5—Debug Server—Recites the address of the debug server.
Press 1 to change, or * to go back.
The following table lists the IVR options that you can enter immediately after
accessing the IVR system.
Number Option
100 Indicates that Dynamic Host Configuration Protocol (DHCP) is enabled.
110 Recites the IP address of the phone.
120 Recites the netmask of the phone.
130 Recites the gateway address.
140 Recites the MAC (hardware) address of the phone.
150 Recites the phone software version.
160 Recites the primary DNS server address.
170 Recites the HTTP port on which the web server listens. Defaults to 80.
180 Recites the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone).
220 Recites the method of call control (SIP or SPCP).
221 Set call control—enter the value for the call control method and press #:
•0: SIP
•1: SPCP
To s a ve , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738 Restores the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
Downloaded from www.Manualslib.com manuals search engine