Operation Manual

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 27
1
Some menus require entering of more information or numbers.
Press 9 on the IVR menu to be guided through a list of commonly used tasks or
enter the number of the desired menu to go directly to that feature.
Enter the number of the settings you want to change:
• 1—Network
- 1—Connection Type—Recites the connection type.
Press 1 to change the connection type, then press 0 for DHCP or press 1
for static IP.
To s a v e , p r e s s 1.
To r e v i e w, p r e s s 2.
To r e e n t e r, p r e s s 3.
To e x i t , p r e s s *.
- 2—IP Address—Recites the IP address
- 3—Netmask—Recites the network mask.
- 4—Gateway Address—Recites the gateway IP address.
- 5—MAC Address—Recites the MAC (hardware) address.
- 6—DNS—Recites the primary DNS server address.
• 2—Protocol
- 1—Call Control Protocol—Recites the current call control protocol.
Press 1 to change, or * to go back.
- 2—Multicast Address—Recites the multicast address.
Press 1 to change, or * to go back.
- 3—CDP—Tells you if CDP is enabled.
Press 1 to change, or * to go back.
- 4—SPCP Auto Detection—Indicates that SPCP auto detection is
enabled.
Press 1 to change, or * to go back.
• 3— Other Options
- 1—Software Version—Recites the software version.
- 2—Primary Extension—Recites the primary extension.
- 3—Reboot—Reboots the phone. Hang up to exit.
Downloaded from www.Manualslib.com manuals search engine