Operation Manual

Provisioning

Updating Profiles and Firmware

Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 167

Launch a Profile Update by using a Browser Command

Cisco SPA IP phones can synchronize to specific profiles stored on a remote

server. The phone resyncs only when it is idle. The update is attempted

automatically after the call is complete.

To update the phone profile, enter this command:

http://phone-ip-addr/admin/resync?protocol://server-

name[:port]/profile-pathname

• phone-ip-addr is the IP address of the phone.

• Parameter following resync? defaults to the Profile Rule setting on the

web server Provisioning page.

• protocol defaults to TFTP.

• server-name defaults to the host requesting the URL.

• port defaults to:

- 69 for TFTP

- 80 for HTTP

- 443 for HTTPS

• profile-pathname defaults to the path for the new synchronization

profile (for example, http://192.168.2.217admin/resync?tftp://

192.168.2.251/spaconf.cfg).

Rebooting a Phone by using a Browser Command

You can remotely reboot a Cisco IP phone by entering a command in a web

browser URL field.

To reboot a phone, enter the following command:

http://phone-ip-address/admin/reboot

• phone-ip-addr is the IP address of the phone.

Downloaded from www.Manualslib.com manuals search engine