Installation guide

Cisco 4000-M ROM Monitor E-5
Entering the Cisco 4000-M ROM Monitor Program
The time to run a diagnostic is memory-size dependent. It will take a minimum of ten
minutes. If the program encounters memory problems, it will display appropriate error
messages on the console terminal. Be sure to reinitialize the processor before booting the
system by entering i at the ROM monitor prompt.
Running the Diagnostics
Take the following steps to run the ROM monitor diagnostics:
Step 1 Turn OFF the unit.
Step 2 Restart the router.
Step 3 Within 60 seconds, press the Break key on the console terminal to force the server
into the ROM monitor. Wait for the server to print the two-line banner message
and for the (>) prompt to appear.