Installation guide

Replacing Memory in Cisco 4000 Series Routers C-15
Replacing the Cisco 4500-M and Cisco 4700-M Boot Helper Flash Memory SIMM
Figure C-8 Inserting Flash-Memory SIMMs
The socket guide posts insert
through the SIMM holes
(on both sides).
3.
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
4.
H2474
Polarization
notch
1. Insert the SIMM into the socket at an angle 45° from vertical.
The socket guide posts insert
through the SIMM holes
(on both sides).
3.
The locking spring will
clip the front side of the SIMM
when it is fully installed
(on both sides).
4.
Side view
2. Push the SIMM down and back.
2. Push the SIMM down and back.
1. Insert the SIMM into the socket at an angle 45° from vertical.
Top view
Front of the chassis