Installation guide

5-8 Cisco 4000 Series Installation Guide

Configuring the Router

Step 3 Enter yes (the default) or press Return when you are asked if you would like to

enter the conﬁguration dialog and if you would like to see the current interface

summary.

Would you like to enter the initial configuration dialog? [yes]:

First, would you like to see the current interface summary? [yes]:

Any interface listed with OK? value "NO" does not have a valid

configuration

Interface IP-Address OK? Method Status Protocol

Ethernet0 unassigned NO not set up down

Ethernet1 unassigned NO not set down down

Serial0 unassigned NO not set down down

Serial1 unassigned NO not set down down

Serial2 unassigned NO not set down down

Serial3 unassigned NO not set down down

Step 4 Choose which protocols to support on your ﬁrst Ethernet interface. For IP-only

installations, you can accept the default values for most of the questions. A

typical conﬁguration using IP, Internetwork Packet Exchange (IPX), and

AppleTalk follows:

Configuring global parameters:

Enter host name [Router]: router

Step 5 Enter the enable secret password, the enable password, and the virtual terminal

password:

The enable secret is a one-way cryptographic secret used

instead of the enable password when it exists.

Enter enable secret : shovel

The enable password is used when there is no enable secret

and when using older software and some boot images.

Enter enable password : trowel

Enter virtual terminal password: pail