Technical data

Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR

How to Configure the Cisco SM-X Layer 2/3 ESM on the Router

Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR

Step 2 Exit the session from the switch, press Ctrl-a and Ctrl-q from your keyboard:

Example:

Switch# <type ^a^q>

Thanks for using picocom

Router#

Understanding Interface Types on the Cisco SM-X Layer 2/3 ESMs

The Cisco SM-X Layer 2/3 ESM supports the following types of interfaces:

• Ethernet internal interfaces on the host

• Gigabit Ethernet interfaces on the module

• VLAN switched virtual interface (SVI) on the module

Using Interface Configuration Mode

You can configure the individual Cisco SM-X Layer 2/3 ESM physical interfaces (ports) through interface

configuration mode on the CLI.

• Type—GigabitEthernet (gigabitethernet or gi) for 10/100/1000-Mbps Ethernet ports.

• Module number—The module slot number on the Cisco SM-X Layer 2/3 ESM or switch (always 0

on the service module or switch).

• Port number—The interface number on the Cisco SM-X Layer 2/3 ESM or switch. The port numbers

always begin at 1, starting at the left side of the Cisco SM-X Layer 2/3 ESM, for example,

interface

GigabitEthernet 0/1.

You can identify physical interfaces by physically checking the interface location on the

Cisco SM-X Layer 2/3 ESM. You can also use the Cisco IOS show privileged EXEC commands to

display information about a specific interface or all the interfaces on the Cisco switching

service module.

Example

To specify Gigabit Ethernet port 4 on a standalone Cisco SM-X Layer 2/3 ESM, enter this command in

global configuration mode:

Switch(config)# interface GigabitEthernet 0/4